Categories

USB-1747-CP3:USB adapter for AB SLC 5/03,5/04,5/05 PLC

USB-1747-CP3:USB adapter for AB SLC 5/03,5/04,5/05 PLC
USB-1747-CP3:USB adapter for AB SLC 5/03,5/04,5/05 PLC USB-1747-CP3:USB adapter for AB SLC 5/03,5/04,5/05 PLC USB-1747-CP3:USB adapter for AB SLC 5/03,5/04,5/05 PLC USB-1747-CP3:USB adapter for AB SLC 5/03,5/04,5/05 PLC
Product Code: USB-1747-CP3
Reward Points: 0
Availability: In Stock
Manufacturer: Replacement OEM Made In China, Not original
Price: $45.00
   - OR -   

USB interface ALLEN BRADLEY SLC 5/03,5/04,5/05 PLC programming adapter.

USB 1747-CP3 USB programming cable for A-B PLC.Fully supports RS Linx communications with Controllogix,Flexlogix and SLC5/03-05 PLCs.Supports Micrologix and PLC5 with adapter 9 pin Female connector on PLC side.

Introduction
USB-1747-CP3 programming cable simulates the computer's USB interface as
the traditional serial (known as COM interface), thus various existing
programming softwares,communication softwares, monitoring softwares and
other applications can be normally used. The two-color LED on the converter
box indicates data’s transceiving status.
USB-1747-CP3 programming cable is applicable to Allen Bradley SLC 5/03、
5/04、5/05 PLC.
USB-1747-CP3 principle and figure structure:

Functions
●Support USB-1747-CP3 operating system: Windows2000/XP
(WinNT4/95/98/Me/DOS not included)
● support USB-1747-CP3 programming software version:RS Logix 500
and above
● fully compatible with USB 2.0 standard
● USB bus-powered, the current consumption of about 50 mA
● each PC only supports a USB cable programming
● temperature: -20 ~ +75 ℃
● Cable length: three meters, colors: black

System requirement
Please make sure your PC is IBM PC compatible and has the following
system requirements before using the USB programming cable.
● Intel is compatible with 586DX4-100MHz CPU or higher
● A standard USB port (4-pin A plug)
● Operating system is Windows2000 or Windows XP

Setting of RSLogix
After completing Driver installation, the corresponding COM port for the
USB-1747-CP3 programming cable will be displayed in the “Device Manager”
of Window. The step next is just to choose this COM port in the programming
software and other application software and keep other communication
parameters as in the Default settings. And the following steps are exactly the
same as in the traditional programming cables with RS232 interfaces.

 

 

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below: